ReChargX
™
RX411
8am - 5pm ET Mon - Fri
© 1995-2016 ReChargX, EmptyX, TonerRefillKits, TonerRefillKits.com, the TonerRefillKits logo, the
V1.00 - 2016.05.03
800.527.3712 or 352.343.7533
ReChargX and EmptyX logos are trademarks owned by TonerRefillkits.com, LLC. All rights reserved.
Page 4 of 15
Dell uses a “page counting” mechanism (a
combination of gears and “flags”) to report to the
printer when the cartridge is either full or used.
Before we begin the refill procedure we will address
the components of the reset mechanism that either
have to be removed or replaced.
Without properly resetting/addressing these
mechanisms, even after the cartridge has been
refilled the cartridge would still appear to the printer
as being empty resulting in a false “toner low” or
“toner empty” message.
Although the starter, standard-yield, and high-yield
toner cartridges are fundamentally the same, each
requires a slightly different process to reset the page
counting mechanism.
Skip forward to the appropriate page for the reset
procedures specific to your cartridge.
If you are working on a
starter cartridge
(the
cartridge included with the printer) proceed to
and follow steps 7a-7c.
If you are working on a
standard-yield cartridge
proceed to
and follow steps 8a-8e.
If you are working on a
high-yield cartridge,
proceed to
and follow steps 9a-9e.
Figure A:
The starter cartridge (with end cap removed)
Figure B:
The standard-yield cartridge (with end cap removed)
Figure C:
The high-yield cartridge (with end cap removed)
Identifying the toner cartridge type
