ReChargx RX022, Инструкция по эксплуатации

Страница: 6 / 7

TonerRefillKits.com RechargX™ RX022
Mon - Fri 8am - 5pm ET © 1995-2011 ReChargX™, EmptyX, TonerRefillKits and TonerRefillKits.com, the TonerRefillKits logo, the 2011.05.20
800.527.3712 or 352.343.7533 ReChargX™ and EmptyX logos are trademarks owned by TonerRefillkits, LLC. All rights reserved. Page 6 of 7
Step 14: Remove the Excess Plastic From
the Hole-Making Tool
Using the tip of the flat-blade screwdriver,
included in the ReChargX Tool Kit, remove the
small piece of plastic from the copper tip of
the hole-making tool, as shown in figure 15.
This small piece of plastic is impossible to remove
once it becomes cold and hardens to the copper
tip of the hole-making tool.
Step 15: Empty the Waste Toner Hopper
Now we will remove the waste toner from the
toner cartridge.
Note : This toner cannot be used again as
paper, dust, hair, staples and other small
items can accumulate in the waste hopper.
Holding the cartridge over the newsprint,
included in the ReChargX™ RX022 Refill Kit,
carefully pour out any waste toner, as shown
in figure 16.
If the waste toner stops flowing, stand the
cartridge up again and then re-lower the hole
over the paper (gently tapping along the side
of the toner cartridge helps to keep the toner
flowing as well).
Note : There is no need to attempt to remove
every last bit of waste toner from the hopper,
just that which comes out easily.
Step 16: Clean the Area Around the
Waste Hopper Hole
After the waste toner has been removed from
the waste hopper, use the yellow/orange toner
grabber cloth to clean around the waste hopper
hole, as shown in figure 17, so the ReChargX™
leak-proof seal will adhere to the cartridge body
as completely as possible.
Figure 15 : Remove the excess plastic piece
Figure 16 : Empty the waste toner
Figure 17 : Clean the waste hopper hole