8
Charging Procedure
(Fig. 1,2,3,4)
Battery can be charged outside the machine (Fig.1) or on the machine (Fig 2-3). It is
recommended to charge the battery pack outside the machine, If charging on the machine,
the switch will lose function and machine cannot be started during charging process.
1. Open the rubber cover to see charging inlet (16) on the battery pack. (Fig.4)
2. Insert the charger cable into charging inlet (16). (Fig.3)
3. Making sure the wall outlet in your home is normal household voltage (AC110V, 60Hz)
insert the battery charger plug into the mains power supply.
4. There is an LED charging indicator on the battery charger. One is red and the other is
green. The red LED charging indicator (18) on the charger lights up to tell you that the
battery pack is low on charge. The battery is fully charged when the red LED charging
indicator lights up GREEN (18). Use the rubber cover to close the charging inlet.(Fig.4)
During the charging process, the surface of the battery will warm up, but this is
perfectly normal.
When not using the tool for extended periods, disconnect the charger.
Only charge the battery between 10
º
- 45
º
C (50
˚ – 113˚F)
After prolonged use, allow battery to cool down before recharging.
Store batteries indoors at room temperature during extreme cold conditions.
Assembly
For Your Safety
Remove battery before any adjusting or cleaning and before leaving the
machine unattended for any period.
Do not insert the battery until the hedge trimmer is completely assembled.
The blades continue to move for a few seconds after the cordless trimmer is
switched off. Do not touch the moving blades.
Ensure that the cordless trimmer is assembled in the following order:
1. Fitting the Front Handle
The front handle must be assembled before use:
Make sure the lock spanner (10) is in the unlock position. Unscrew the locking bolt (9)
of the front handle with screw driver (not supplied) and pull it out . (Fig.5-6)
Fig. 5
Fig. 6
