
Owner’s manual
13
EN
IMPORTANT! Only one CD, DVD or credit card can be shred at a time.
6. CDs and DVDs are shredded into three pieces which are collected in a
dedicated tray inside the wastebasket.
•
Make sure to empty the tray regularly!
PAPER JAMS
If the following situations occur, the cutting head may jam:
1. Too much paper was inserted into the paper entry slot in single pass.
2. Paper was inserted incorrectly into the paper entry slot.
3. Inserted paper was not stacked neatly.
4. Paper was crumpled.
5. The wastebasket is overfilled with cutting waste.
To clear the jam, set the Mode switch to REV position. Cutting head runs in
reverse ejecting the paper out.
OVERHEAT PROTECTION
If continuous operation of the device exceeds 2 minutes, motor may overheat
and the device will automatically turn off. Please wait around 30 minutes until
motor temperature drops to the safe level. Then turn on the device by setting the
Mode switch to AUTO position.
CLEANING AND MAINTENANCE
•
Make sure to disconnect the device from power supply socket prior to cleaning.
•
Clean this device with soft, slightly damp cloth. Do not use any abrasives or
chemical agents to clean this product.
•
Empty the wastebasket regularly. Otherwise, the cutting head may jam due to
overfilling.
Note! Make sure to set the Mode switch to OFF position before emptying
the wastebasket.
•
If necessary, use a suitable tool to remove jammed paper from the cutting
head.
CAUTION!
•
Make sure to unplug the device from power supply socket before manual