02
Installation Guide & Function Descriptions
Start
Event Record Mode
19
JS-300G_v3.indd 19
2009-09-10 ¿ÀÈÄ 4:38:57
Insert SD Card into RVS-300 / RVS-300G, then power on.
Red
,
Yellow
and
Blue
LED will light sequentially at a second interval.
About 3 seconds after lighting, RVS-300 / RVS-300G will start running.
If it powers on without SD Card,
Red
and
Green LED
will be blinking alternately at 0.5 sec interval. In
this case, disconnect the power and connect power again after inserting SD Card.
1.
Recording is run based on Event and Normal record mode
(Full Time Mode)
, and the
present recording mode is saved and memorized into Configuration Variable
Setting File in SD Card.
(The Factory default record mode is Event Mode and it would be same after formatting SD Card.)
2.
To change the recording mode, connect power under the status of pressing
Emergency key simultaneously.
The mode will be changed either Event Record mode to Normal Record Mode or
Normal Record Mode to Event Record Mode.
The changed recording Mode would be saved into SD Card and maintained until
the mode is changed by user.
When pressing the Emergency Key, press until
Red LED
turns on.
2.
During Event Record Mode,
Red LED
is blinking at one second second intervals.
1.
When the impact value recognized by G-Sensor
(acceleration sensor)
is bigger than
user-defined value or when user presses Emergency key manually, the image and
voice before 10 seconds and after 20 seconds of the event will be saved as a file.
When an event occurs,
Red LED
will be blinking rapidly at 0.1 second
intervals for 3 seconds and inform of it.
2.
If another event occurs while the previous event is being saved, the second event
will be ignored.
(If emergency record is required, just press Emergency button and recording will be started. After
recording, the mode will be back to Event Record Mode.)
Event can be recorded up to 100 times as a file, and from the file recorded first it would be overwrit-
ten sequentially when the number of file is exceeding the maximum.
3.
When the power is disconnected on Event Record Mode, RVS-300 while recording
an event, it will shutdown after saving the event, maximum 20 seconds. Otherwise
it will shutdown instantly.
4.
`the Stop Key is pressed, RVS-300 / RVS-300G will complete recording the event
and all functions will be stopped.
(All LED lights will be off.)
To start RVS-300 again, disconnect power and reconnect.
5.
