14
7
LOW
Control Knob
PUSH
IN
1. Read and understand all operating instructions before lighting.
2. Burner control knob mus
t be in the “OF
F” position.
3. Connect propane (LP) cylinder (see above pages).
4. Slowly open valve on LP gas cylinder.
5. Push and hold igniter button to create sparks.
6. While holding the igniter button with one hand, use
your other hand to push and turn the control knob
to the “LOW” position to light the burner.
7.
K
eep Burner Contr
ol Knob p
ressed in for 15-30 seconds after ignition.
8. If ignition does not occur in 30 seconds, turn control knob to the “Off” position and turn
gas off at the source, wait 5 minutes until gas has cleared and repeat lighting procedure.
Please refer to the trouble shooting, and helpful tips sections for
additional support, beginning on page 17.
Using the ignitor
WARNING
When using this method to light
your fire table use heat resistant
gloves and follow the step by step
instructions. Failure to do so could
result in severe injury.
9. Adjus
t the flame
to the desired height with the control knob.
WARNING
If burner flame goes out during ope
ration,
immediat
ely turn the control knob “OF
F” and let the
gas clear a minimum of 5 minutes before attempting
to re-light the fireplace.
!
!
Lighting Instructions
!
WARNING
Do not wear loose or flammable clothing while
lighting fire table.
Using a Long Match or Lighter
2.
1. Prior to lighting, use a shovel to move the
lava rocks for access to the burner.
5. After lighting, use a shovel and heat resistant
gloves to carefully move the lava rocks back into
their proper position.
Wearing heat resistant gloves, position
lighter near the side of the burner. DO NOT
lean over the fire table while lighting!
the burning long match or burning butane
3. Turn control knob counterclockwise t
o “LOW”.
4. Remove long match/long butane lighter.
6. Adjus
t the flame
to the desired height with the
control knob.
7
