8
Lighting Instructions
13
PILOT
Control Knob
PUSH
IN
1. Read and understand all operating instructions before lighting.
2. Burner control knob must be in the “OFF” position.
3. Connect Natural Gas source (see above pages).
4. Open the Natural Gas supply to the unit.
5. Push and hold igniter button to create sparks.
6. While holding the igniter button with one hand, use your other hand to
push and turn the control knob to the “Pilot” position to light the pilot
flame. If ignition does NOT immediately take place on pilot, turn the
burner control knob to "OFF", wait 5 minutes for gas to clear and repeat
the lighting procedure. If pilot still will not light, refer to the Troubleshooting Section.
7. After ignition, release the igniter button and keep Burner Control Knob pressed in for 15-30
seconds after ignition.
8. Release burner control knob. Pilot flame will remain lit. If not, return to Step 1.
Using the Igniter
WARNING
When using this method to light
your fire table use heat resistant
gloves and follow the step by step
instructions. Failure to do so could
result in severe injury.
9.
*!ƫ0$!ƫ,%(+0ƫ%/ƫ(%0Čƫ01.*ƫ0$!ƫ1.*!.ƫ+*0.+(ƫ'*+ƫ0+ƫŎ+3Ŏƫ,+/%0%+*ċƫ%*ƫ1.*!.ƫ3%((ƫ(%#$0ƫ
immediately. If not, turn control knob to the “O
ff
” position and turn gas o
ff
at the source,
wait 5 minutes until gas has cleared and repeat
lighting procedure. If main burner still will not light,
refer to the Troubleshooting Section.
WARNING
If burner flame goes out during operation,
immediately turn the control knob “OFF” and let the gas
clear a minimum of 5 minutes before attempting to re-light
the fireplace.
!
!
WARNING
!
Do not wear loose or flammable clothing
while lighting fire table.
Using a Long Match or Lighter
1. Prior to lighting, use a shovel to move the lava rocks for access to the pilot.
5. Once the pilot is lit, turn the burner control knob to
ƫƫƫƫŎ+3Ŏƫ,+/%0%+*ċƫ%*ƫ1.*!.ƫ3%((ƫ(%#$0ƫ%))! %0!(5ċƫ
If not, turn control knob to the “O
ff
” position and turn
gas o
ff
at the source, wait 5 minutes until gas has
cleared and repeat lighting procedure. If main burner
still will not light, refer to the Troubleshooting Section.
Wearing heat resistant gloves, position the burning long match or burning butane
lighter near the pilot. DO NOT lean over the fire table while lighting!
3. Turn control knob counterclockwise to “Pilot” to light the pilot flame. If ignition
does NOT immediately take place on pilot, turn the burner control knob to "OFF",
wait 5 minutes for gas to clear and repeat the lighting procedure. If pilot still will not
light, refer to the Troubleshooting Section.
4. Remove long match/long butane lighter.
7. Adjust the flame to the desired height with the control knob.
Note: For initial start or after any cylinder change, continue to push the Control Knob IN
for 2 minutes to purge air from gas lines before proceeding.
10. Adjust the flame to the desired height with the
control knob
6. After lighting, use a shovel and heat resistant gloves to carefully move the lava rocks back
into their proper position.
