3
Security precautions
Installation of the Dreamoc must be done according to this manual, and must
be performed by an adult (Over 21 years).
The Dreamoc must be placed on a horizontal, stable and plane surface. The
floor stand must be fitted with sufficient ballast as described in this manual.
Do not install the Dreamoc in narrow passageways or other places where a lot
of people and equipment has to pass close by, thereby risking collisions that
might cause the Dreamoc to tip over causing human injuries and damage to
property.
The Dreamoc must be connected to a power outlet with current and voltage
as described in the product marking.
Turn off the Dreamoc before changing the Compact Flash card.
During service and cleaning the Dreamoc must be turned off, and the power
plug removed from the outlet.
To disconnect the apparatus from the mains,
the plug must be pulled out from the mains socket, therefore the mains plug
shall be readily operable.
Handle the liquid crystal display (LCD) with care.
The LCD is a very delicate
display device: Do not press its surface with excessive force, hit it or prick it
with a
sharp object.
No sand or dust! Fine sand or dust entering the system could cause
malfunctions or defects.
No water or oil! Water or oil entering the system could cause electric shock,
malfunctions or
defects.
The surface of the system will be slightly warm when using, but this does not
indicate a fault.
Be careful of unusual ambient temperature. Using the system in a place
where the temperature is over 40°C (140°F) or lower than 0°C (32°F) may
result in malfunction.
Do not place the Dreamoc in direct sunlight or near magnetism, corrosive gas
or ultrasonic humidifier. This could cause malfunction.
Do not expose the Dreamoc to soot or steam. Thick soot or steam could
damage the electrical components and cause malfunctions.
Keep the memory card out of reach of children to prevent swallowing.
