Real Carriage Door & Sliding Hardware Copyright 2020© all rights reserved
Installation
Instructions
•
Wood drill 3/16”
•
Concrete drill 1/4”
•
Wrench 1/2” and 3/8”
•
Ratchet driver 1/2” and 3/8”
Connecting the rails
1. Take your rails and parts boxes out and set
aside
2. Slide the bridges (part 3) onto each end of Part
2 (track with motor carriage)
3.
Proceed to slide other rails (part 4) into the
bridges until they meet with the edges of Part 2
4.
Stretch the chain
across the length of
the track
Chain Tensioner
Note:
Chain tensioner is installed on closing end of
the rail, while as the wire connector is on the open
end.
1. Slide chain tensioner (part 5) into the closing
end of the track (away from the doors)
2. Stretch the chain
3.
Rotate it 90 degrees so it slides into the chain
holder
4.
Make sure the tensioner is loosened before
attaching chain
5. Rotate the chain back so it locks into place
Page 14
Installation
