Real Flame VEKTOR 1100, Инструкция по установке и эксплуатации, Страница: 45 / 56

45
BURNER PRESSURE ADJUSTMENT
Burner test point pressures must be set whilst appliance is running.
1. Turn appliance off at remote control.
2. Remove outer glass safety screen
3. Remove lower cover
4. Remove electrical cover
5. Loosen burner pressure test point screw and fit manometer to barb.
6. Turn on appliance and set remote control at least 3 deg C above room temperature. Heater will
run on low (minimum) burner pressure for 3 minutes then automatically increase to high rate.
7. After 3 minutes heater defaults to high speed (ensure remote control is showing maximum flame)
Using 10mm spanner or similar adjust maximum gas rate by turning outer brass nut to the correct
test point pressure kPa.
8. Turn appliance down to minimum rate using remote control (adjust setpoint temperature to be
1deg lower than the room temperature).
9. While remote is set to low flame - Using Phillips or small flat screwdriver, adjust minimum
pressure to the correct test point pressure kPa by turning red plastic screw.
10.Turn appliance up to maximum rate using remote control (adjust setpoint temperature to be 3deg
or more than the room temperature).Check maximum test point pressure, adjust if required.
11.Turn appliance down to minimum rate using remote control (adjust setpoint temperature to be
3deg or more than the room temperature).Check test point pressure, adjust if required.
12.Confirm maximum and minimum pressures are correct.
13.Turn appliance off at remote control.
14.Remove manometer and tighten test point screw.
15.Start appliance and check test point for gas leaks where necessary.
16.Refit panels.
17.Refit safety glass screen.
Outlet test point pressure Max pressure
adjustment nut
Low pressure
adjustment screw
Inlet gas pressure
test point