Real Carriage Door & Sliding Hardware Fremont Opener, Руководство по установке

Страница: 26 / 38

Set the red limit for the open position by disengaging the motor. To do this
pull the red chord (emergency release) until it disengages. This will allow
you to move the doors freely to see where the doors need to stop. Position
the red stop accordingly and be sure to tighten down.
ADJUST THE RED LIMIT STOP
1. Place the door in the halfway open position and re-engage the motor
by pulling the red emergency release chord
2. Use the remote for programming the opener, the one included (in the
main box with the opener) is preprogrammed already for your conve-
nience
NOTE: Only the 1st button is used on the remote for programming pur-
poses
3. Plug the motor into your power outlet. The status light on the control
board should blink rapidly
• It is recommended to leave the motor carriage cover off during
install
4. Press 1st button on the remote until the motor carriage starts to move
and release quickly
5. To set the close limit you must program the position for the opener to
learn during autoset
• The motors are very strong and will try to pull through the resis-
tance while it is in learning mode and will possibly result in bending/
breaking hardware
• The best way to set the closing limit is to use the remote to stop the
door right before hitting the jamb
• Hold down the 1st button on your remote to activate the hop func-
tion and release as soon as it moves
• The opener will make small jumps forward
• Continue this until you reach the desired stop location
AUTOSET PROGRAMMING
2
4
ADJUS
T
RED S
T
OP
LIMIT
&
A
UT
O
SET
PR
OGRAMMING