- Power adapter
- Factory Settings
Power Adapter
1. Connect the Network and Power
Connect the DC plug on the power adapter to the DC port on the device and connect the other
■
end of the power adapter into an electrical power outlet.
Connect the ethernet cable between the Internet port on the device and the network port on a
■
router or switch to access LAN.
IP Address
1. Find out your ReadyNet AC1200MS IP Address
For ReadyNet AC1200MS lift the handset and enter ****, choose "1" and then choose "2", the
■
IP address will be recited.
Factory Settings
1. Reset to factory settings
This step is not required for out-of-the-box devices, however, if the device has been already used
then it is a must.
For ReadyNet AC1200MS press the reset button at the front of your router for 10 seconds, this
■
will wipe out any changes made to your router.
Device will be reset to the factory default settings.
Wait sometime prior for device to reboot.
■
NOTE:
Do not unplug or remove power to the device while it is updating firmware and
configurations.
Registering Device
This chapter describes how to identify ReadyNet AC1200MS device model, requirements that
must be met and how to register the device using manual configuration or auto provisioning.
The following topics are covered:
- Manual Configuration
- Auto Provisioning
Manual Configuration
This chapter describes how to set UAD settings, create PBXware extension and register the
device.