www.ReadyLIFT.com - Phone: (800) 549-4620
Installation Instructions 69-2300 / 2301 / 2302 / 2303
7
7-20-16 MMC
Install the vacuum lines, ABS, and brake line brackets into their loca-
tions on the frame using the factory hardware. You will leave the
ABS lines loose from the inner wheel well. Torque brackets to
10 ft-
lbs
.
(Fig 20)
Install the wheels and lower the vehicle to the ground. Torque the lug
nuts to the manufactures specifications.
Reconnect the vehicles negative lead at the power source and the
EPAS module.
Jounce the front suspension to get the vehicle to settle to ride height.
Torque the upper and lower control arms to
120 ft-lbs
.
Rear Install
Block the front wheels and raise the rear of the vehicle. Place jack
stands under the frame rails ahead of the spring hanger.
Place a suitable jack under the rear end for support.
Slightly loosen but do not remove the driver side u-bolts. Remove
the passenger side u-bolts completely and discard. Lower the axle
just enough to remove the factory block and install the lift block. Lo-
cate the passenger side lift block, making sure the tapered end points
to the front if installing on a 1 piece drive line. If installing on a 2
piece drive line, the blocks are universal. Install the lift block on the
axle pad aligning the pins. Raise the axle and the block up to the
spring while aligning the center pins. Install the provided
u-bolts,
washers and nuts
. Snug the u-bolt nuts but do not fully tighten at this
time. Repeat steps for driver side.
(Fig 21, 22, 23)
Lower the vehicle to the ground and jounce the suspension.
Torque the u-bolts to
110 ft-lbs
.
Install carrier bearing drop if on a 2 piece drive line. Torque to
40 ft-
lbs
.
(Fig 24)
FIG 19
FIG 20
FIG 21
FIG 22
FIG 23
FIG 24