www.ReadyLIFT.com
-
Phone: (877) 759
-
9991
8
46
-
5780
-
IM
-
AA
Note: If coil
-
overs are being installed on
the
6”
lift kit, the preload collar will need
to be adjusted for that application.
Loosening the preload collar set screw and
turning the collar counter
-
clockwise to
raise the collar. Measure the distance be-
tween the top of the preload collar and
the edge of the top cap (as shown). Ap-
proximate distance should be
4.75”.
Install the coil
-
over assembly into the ve-
hicle using the supplies M10 flange nuts.
Install the rod end misalignment spacers
into the rod end ensuring the large spacer
is toward the front and the small is toward
the rear of the vehicle.
Swing lower control arm up into place and
install the coil
-
over rod end into the con-
trol arm pocket using the factory strut
hardware.
Install the appropriate reservoir bracket
by removing the sway bar bracket hard-
ware and sliding the bracket in between
the frame rail and the sway bar drop
bracket. Install the factory sway bar
bracket hardware.
Torque to the hardware to
45 ft
-
lbs
.
Note: Brackets are side specific and need
to be installed with the offset towards the
rear of the vehicle.
Route the reservoir between the upper
control arm and the tie rod.
Install reservoir to the bracket using the
supplied
#48 hose clamps
.
Hose clamps are to be routed through the
slots in the bracket.
