www.ReadyLIFT.com
-
Phone: (877) 759
-
9991
26
44
-
19620
-
IM
-
AA
Route the ABS wire between the knuckle
and the strut. Ensure the ABS wire is
routed over the CV axle as well.
Install the opposite side ABS wire bracket
on the inside of the knuckle using the
factory hardware (i.e. Driver will be
installed on passenger side).
NOTE: It may be necessary to trim the
end of the ABS wire bracket to allow the
bracket to sit flush on the knuckle.
Torque the factory hardware to
10 ft
-
lbs.
Remove the ABS wire harness retaining
clips that are attached to the frame rail.
This will allow additional length that is
required to install the ABS sensor into the
knuckle.
Install the ABS harness connector into the
preexisting hole located on the side of the
frame rail.
Install ABS sensor into knuckle using the
factory hardware.
Torque the factory hardware to
80 in
-
lbs.
