7
CHIMNEY CONNECTOR (also known as "flue pipe" or "stove pipe").
The chimney connector joins the stove to the
chimney. It should be 6" inches in diameter, carbon steel, 24-gauge minimum.
THIMBLE.
A manufactured or site-constructed device installed in combustible walls through which the chimney
connector passes to the chimney. It is intended
to keep
walls from igni ti ng.
CHIMNEY.
[See specifications on Pages 8-10.] APPROVED MASONRY with at least 5/8” fire clay lining joined with
refractory cement or other listed lining system suitable for use with coal stoves, or PREFABRICATED 6- or 8-inch
listed high temperature* residential type and building heating appliance chimney. Components required by
manufacturers for installation such as the chimney support base, firestop (as appropriate), attic insulation shield,
insulated tee, etc., are necessary to assure a safe chimney installation. Use only components manufactured for the
chimney.
FLOOR PROTECTOR.
1
l4
"
Mineral board or equivalent. Measurements: 8" beyond the sides and back; 18" beyond the
front. Total Dimensions: 40" x 45" or larger.
SAFETY NOTICE
Avoid Fire
Maintain the designated clearance distance to combustibles.
Insulation must not touch the chimney. There must be the
designated air space clearance around the chimney. This air space
around a chimney is necessary to allow natural heat removal from
the area. Insulation in this space will cause a heat build-up which
may ignite wood framing.
IlI. Installation
SAFETY NOTICE
IF THIS STOVE IS NOT PROPERLY INSTALLED, A HOUSE FIRE
MAY
RESULT.
FOR
YOUR
SAFETY,
FOLLOW
THE
INSTALLATION DIRECTIONS. CONTACT LOCAL BUILDING OR
FIRE OFFICIALS ABOUT RESTRICTIONS AND INSTALLATION
INSPECTION REQUIREMENTS IN YOUR AREA. CHECK YOUR
LOCAL BUILDING CODE.
PLEASE READ THIS ENTIRE MANUAL BEFORE YOU INSTALL
AND USE YOUR NEW STOVE. FAILURE TO FOLLOW
INSTRUCTIONS MAY RESULT IN PROPERTY DAMAGE, BODILY
INJURY, OR EVEN DEATH.
