REACH CL4000
（
Powolive
™）
User Manual
Copyright © SZ Reach Tech Co., Ltd.
9
/
47
2. DVI input port
2. HD-SDI input port
2.2 Connect Cables
1. Put the device at the even and flat position.
2. Connect the SD video source, HD video source or computer signal source to the
corresponding module input ports with the corresponding video cables according
to the actual modular configuration of the device. To loop out the signals, connect
the device loop out port to the display equipment or matrix with the corresponding
video cables.
3. Connect the audio source to the audio input port Line In with the stereo audio
cable. If there is microphone input, connect the microphone cable to the port Mic
In.
4. To control the camera PTZ, connect the camera PTZ control port with the device
serial port with the serial port cable.
5. Connect the network cable to the device’s network port, so that the device will be
connected to the network planned by the network administrator.
6. Connect the power of adaptor to the power interface and plug the adaptor to the
power socket.
III Get Started
3.1 Startup and Shutdown
Before starting up the device, please make sure that the cables are properly
connected, and then turn on the power switch on the rear panel of the device. The power
