re3D gigabot, Быстрый старт, Страница: 21 / 34

quick start guide
21
C1
C2
Install the spool holder(s)
to the back of Gigabot®
with 2 magic T-nuts and
2 M5x12 BHCS each.
Use the 3mm Allen Key
to fasten the hardware.
Users may decide how far
up or down the rail these
are located.
Mount the filament spool
onto the spool holder.
The filament should feed
from below the spool and
into the corresponding
Filament Detection (FD)
unit. Feed the filament
into the FD unit and all the
way to the extruder until
the tip of the filament sits
between the drive gear
and idler bearing. Wrap
the filament cleaning cloth
around the filament below
the FD unit and secure it
using the spiralite.