re3D gigabot, Быстрый старт, Страница: 18 / 34

quick start guide
18
b11
b12
Use the 8mm combination
wrench to gradually
tighten the M5x12 hex
head screws at each
corner. Periodically use
the business card again
to check the level, since
tightening the hardware
on the rails may have
caused them to move
slightly. The bed cross
rails should be secured
and acceptably level to
the nozzle after 2-3 total
passes.
After the final tightening,
the bed will be securely
held in position and there
will be no need to re-level
unless some external
factor throws it out of level.
If you have any questions
or concerns, please do
not hesitate to contact our
support at
support@re3d.
org .