re3D Gigabot X, Руководство по началу работы

Страница: 18 / 30

IMAGE BOX:
Option A.
1. Place Image
2. Sent to Back
IMAGE BOX:
Option A.
1. Place Image
2. Sent to Back
IMAGE BOX:
Option A.
1. Place Image
2. Sent to Back
18
Set the [11484] GBX hopper on top of the
hopper trolley by first inserting the feed tube
through the center of the hopper trolley from
above.
C1
Attach the [11484] GBX hopper to the hopper
trolley by using a 3mm hex screwdriver to
screw 4 [10242] M5 x 35 FHCS up through
the bottom of the hopper trolley and into the
underside of the hopper.
Note: if the screws aren’t lining up with the
heat-set inserts on the underside of the
hopper, rotate the hopper by 90 degrees.
C2
Insert the feed tube into the top of the feed
throat until it comes to a hard stop against the
inner ridge inside the feed throat. Clamp the
feed tube in place by using a 2.5mm hex
screwdriver to tighten the two screws on the
feed throat clamping section. Then use a 2mm
hex head screwdriver to tighten the two
[11005] M3 x 8 BHCS into the front and back
of the feed throat (only the front is pictured
here).
C3