1
Congratulations / Contents
Features & Installation
Basic Wiring
• 2-channel / Monoblock
•
4-channel
Bridged Wiring
•
2-channel
•
4-channel
Specifications
Troubleshooting
Limited Warranty / Caution
1 •••••••••••••
2 •••••••••••••
3 •••••••••••••
4 •••••••••••••
5 •••••••••••••
6 •••••••••••••
Rear •••••••••
CONTENTS
Congratulations
on your selection of a RE Audio DTS series amplifier.
We take pride in manufacturing our products and you can expect your new amplifier to give you
years of trouble-free service.
To make your installation as easy and reliable as possible, please read this manual carefully before
beginning.
If you need more information, your RE Audio Dealer will be glad to help. To locate a RE Audio
Dealer near you, go to our web site and look for “Locate Dealer.”
6
• Re-adjust the Input Level Control to better suit the input signal.
WEAK OUTPUT
• If the noise is a “whine” whose pitch follows the engine speed, confirm that the
amplifier and any other signal sources (head unit, equalizer, etc) are properly
grounded.
• If the noise is a “clicking” or “popping” noise whose rate follows the engine speed,
this usually means that the vehicle is equipped with resistor spark plugs and wires,
or that the ignition is in need of service.
• Check the routing of the speaker and input wires to make sure they are not
adjacent to wires which interconnect with lights and other accessories.
• If the above steps fail to improve or clear noise interference, the system souled be
checked by a authorized RE Audio Dealer.
NOISE IN THE AUDIO
• Confirm that all terminal strip connections are secure and tight.
• Check the “BALANCE” control on the head unit (or other source) to verify that it
is set to its mid point.
• If you are using the low-level RCA input, reverse the input plugs at the amplifier
(switch the R with the L). If the channel which is silent switches to the other side,
the problem is either in the head unit/other source or the connecting cables.
ONLY ONE CHANNEL WORKS
• Confirm that all terminal strip connections are secure and tight.
• Check both in-line and built-in fuses.
• Confirm that the audio signal source (car radio, equalizer, etc) is connected and is
supplying output signal. To check if the amplifier is supplying signal, unplug the
RCA cables from the signal source (but leave them plugged into the amp) and
briefly tap the center pin of each of the disconnected RCA plugs with your finger.
This should produce a noise (feedback) in your speakers.
NO OUTPUT
Before removing your amplifier, refer to the list below and
follow the suggested procedures. Always test the speakers
and their wires first.
TROUBLESHOOTING
