RDX QuickStation 4, Руководство по эксплуатации продукта

Страница: 17 / 116

O
CTOBER
2015 RDX Q
UIK
S
TATION
4
7
Installing the Rack-Mount RDX QuikStation 4
The RDX QuikStation 4 is designed for installation in a standard (EIA-310) 4-post,
19-inch rack and uses 1 unit (1U) of rack space.

Verify the rack is placed on level ground. Use a level when installing the rack rails
to prevent any potentially hazardous conditions caused by uneven mechanical
loading.

Use a ventilated rack to verify the appliance receives adequate air flow required for
safe operation.

Obtain the following items to complete the rack installation instructions

#2 Phillips screwdriver

Tape measure

Level
Unpacking the Unit
Place the unit and any supplied RDX media on a secure surface. Verify that the
airflow around the front and back of the unit is not obstructed, there is minimal dust,
and there is a minimum of 12cm free space in front of the unit to allow the operators to
safely remove the RDX media.
Installing Rails in Rack
The rack-mounted RDX QuikStation 4 is designed for use in a 19-inch rack using 1U
of rack space. The length of the power cord and the Ethernet cables may restrict
placement.
1. Determine the 1U area where the QuikStation 4 is to be mounted and mark
(4.45cm/1.75 in.) of space on the front rack. At the rear, mark the first and third
holes.
.
2. Measure the length between the front and rear rack mount rails.
QuikStation 4
1U
Mark
(Front)
Mark