Channel programmers (1-8) factory settings: all switches of channels programmers in upper position
(OFF).
1
5
2
6
lider
deputy
Settings of any priorities' configurations: switching of any
switches in any channel's programmer causes the setting of
priority precedence of this channel over the previous
chosen channel. For example: switching in channel no 1
programmer, the switch no 4 down (ON) causes that
microphone no 1 can stop the work of microphone no 4.
Lower configuration (picture no 3) shows the setting of the
priority for the microphone no 1 and no 2 (picture no 2).
The microphone no 1 has the priority over the
microphones from 2 to 8, and the microphone no 2 has the
priority over the microphones from 3 to 8, but is
subordinate to the microphone no 1. It means, that the
speeches of the participants 3-8 can be stopped in any time
by the leader (1) or his deputy (2), but the speech of the
deputy (2) can be stopped only by the leader (1).
7. Priority settings.
TIME-backup time control of active microphones
programmer channels 1-8
ATTACK- switching Microphone level control switch
Adjusting the sensitivity of the channel LINE-CD
Programmer nr 1 - default settings: all switches (1-8) in the
top position (OFF).
Switching any of the eight switches to the bottom position
(ON) turns off the automatic in each channel. This is useful if
you want to use one channel as a linear channel (music).
ATTENTION
! If you want to use priorities, the channel
switch
Programmer 2
- assigning the input channels 1-8 to the channel output mix 1 (MAINSUM 1).
Is assigned to input 1 (IN1) in the DSP.
Programmer 3
- assignment of input channels 1-8 to the mix output channel 2 (MAINSUM 2).
The assignment is to input 2 (IN2) in the DSP and output Jack (MIX OUT).
Programmer No. 4
- factory setting: switches 1 and 2 in position (OFF), switches 3 and 4 in position (ON).
Switch 1 - OUT2 PRE / POST GATE: upper position (OFF) POST GATE - all channels for MAINSUM-2 are
associated with the automation. Lower position (ON) PRE GATE - signals are assigned before automation.
Switch 2 - AUTO / MANUAL: upper position (AUTO) - function automatic operation of the mixer; lower position
(MANUAL) - a standard mixer (the automatic function off).
Switch 3 - ATTENUATION OFF: mute, inactive microphones, top position - muted; lower position - mute -15 dB.
Switch 4 - LAST MIC upper position (OFF) - last used microphone after speaking shuts down,
lower position (ON) - last used microphone after the speech remains active all the time.
WARNING!
If you want to use a priority, this function must be disabled (upper position OFF).
Microphones
3
7
4
8
Pict. 2
Pict. 3
12
8. Priorities settings
