
14-/16-CHANNEL POwER mIxER
4
stage-sound
A. mONO
INPUT-CHANNELS
1. Mic In
This input accepts a standard
XLR microphone connector
and low-impedance micro-
phone.
2. Line In
This input accepts a _” plug
and is suitable for unbalanced
line level sources.
2a. Channel Insert Jack
Allows interface to external si-
gnal processing devices or di-
rect channel output. This patch
point allows you to insert a
compressor, equalizer or any
other signal processing device
into any of the input channel
strips.
3. Low Cut Switch
75 Hz 18 dB/octave low-cut
filter eliminates unwanted sub-
sonic frequencies, while still al-
lowing full use of the low equa-
lization control (8).
4. Line Trim / Mic Gain
Simultaneously adjusts the mic
input gain to accept signals
from -10 dBm to -60 dBm, and
trims the line input to accept
signals from +10 dBm to -40 dBm.
5. High Equalization
Pr/-15 dB of shelving equalization control to boost
or cut high frequency signals 12 kHz and above.
6. Mid Equalization Level
The mid EQ section is a peaking/dipping equalizer with a
range of +/-12 dB. The center frequency is either fixed at 2.5
kHz or set with the mid EQ frequency control (7).
7. Mid Equalization Frequency
This control adjusts the center frequency of the mid EQ con-
trol (6) from 100 Hz to 8 kHz.
FRONT PANEL
VORDERSEITE
A. mONO
EINGANGSKANäLE
1. Mic In
Dieser Eingang akzeptiert ge-
wöhnliche XLR-Stecker und
niederohmige Mikrophone.
2. Line In
Dieser Eingang akzeptiert 6,3
mm Klinkenstecker und ist für
unsymmetrische
Linepegel-
Signale geeignet.
2a. Channel Insert-Buchse
Dient zur Ankopplung eines
externen
Signalprozessors
oder als direkter Kanalaus-
gang. Diese Verbindungs-
stelle ermöglicht das Ein-
schleifen eines Kompressors,
Equalizers oder anderen Ge-
räts zur Signalbearbeitung
in jeden einzelnen Kanal.
3. Low Cut-Schalter
Der Low Cut-Filter (75 Hz, 18
dB/Oktave) beseitigt nicht ge-
wollte Unterschallfrequenzen.
Der „Low Equalization“-Regler
(8) kann jedoch weiterhin in
vollem Umfang benutzt wer-
den.
4. Line Trim / Mic Gain
Stellt den Mic Input Gain so
ein, dass Signale zwischen -10 dBm und -60 dBm ange-
nommen werden. Gleichzeitig wird der Line-Eingang auf eine
Signalakzeptanz zw10 dBm und -40 dBm angegli-
chen.
5. High Equalization
Ermöglicht die Anhebung oder Absenkung der hohen Fre-
quenzen (12 kHz und höher) um +/-15 dB.
6. Mid Equalization Pegel
Ermöglicht die Anhebung oder Absenkung der Mitten um +/-
12 dB. Die zentrale Frequenz ist dabei entweder festgelegt
bei 2,5 kHz, oder sie wird mit Hilfe des Mid-EQ Frequenzreg-
lers (7) ausgewählt.