14-/16-CHANNEL POwER mIxER
12
stage-sound
200 W at 8 ohms. Load impedances less than 4 ohms will
not draw additional power and may cause the unit to go into
protect mode.
The function of these jacks depends upon the position of the
amp mode selector located on the front panel. They provide
either the signal from the left main bus (Stereo setting) or the
combined left and right main signal (L+R/Monitor setting).
Buchse. Die Ausgänge stellen bei 4 Ohm 300 W, bei 8 Ohm
200 W Ausgangsleistung zur Verfügung. Eine Impedanzlast
von weniger als 4 Ohm bezieht keine zusätzliche Leistung
und kann dazu führen, dass das Gerät in den Schutzmodus
übergeht. Die Funktionsweise der Buchsen hängt von der
Stellung des Amp Mode Selectors an der Vorderseite des
Powered Mixers ab. Danach wird entweder das Signal des
linken Main-Busses (Stellung Stereo) oder das kombinierte
Signal vom linken und rechten Main-Bus (Stellung L+R/Mo-
nitor) bereitgestellt.
DSP (DIGITAL SIGNAL PROCESSOR)
EFFECT CHART
01 Reverb Hall 2
5.0 sec.
02 Reverb Hall 2
3.0 sec.
03 Reverb Room
2.0 sec.
04 Reverb Room
1.0 sec.
05 Reverb Plate
3.5 sec.
06 Reverb Plate
1.5 sec.
07 Delay & Reverb
170 ms / 3 sec.
08 Delay & Reverb
300 ms / 5 sec.
09 Delay 50% F.B.
100 ms
10 Delay 50% F.B.
200 ms
11 Delay 50% F.B.
350 ms
12 Delay 50% F.B.
500 ms
13 Chorus & Reverb slow 4.0 sec.
14 Chorus & Reverb med 2.0 sec.
15 Flanger & Reverb slow 4.0 sec.
16 Flanger & Reverb med 2.0 sec.
DSP (DIGITAL SIGNAL PROCESSOR)
EFFEKTLISTE
01 Reverb Hall 2
5,0 sec.
02 Reverb Hall 2
3,0 sec.
03 Reverb Room
2,0 sec.
04 Reverb Room
1,0 sec.
05 Reverb Plate
3,5 sec.
06 Reverb Plate
1,5 sec.
07 Delay & Reverb
170 ms / 3 sec.
08 Delay & Reverb
300 ms / 5 sec.
09 Delay 50% F.B.
100 ms
10 Delay 50% F.B.
200 ms
11 Delay 50% F.B.
350 ms
12 Delay 50% F.B.
500 ms
13 Chorus & Reverb slow 4,0 sec.
14 Chorus & Reverb med 2,0 sec.
15 Flanger & Reverb slow 4,0 sec.
16 Flanger & Reverb med 2,0 sec.