PAGE 4
8
When installing multiple fixtures, always allow a
minimum of 250mm between luminaires.
250mm MIN.
1
Ensure that the track system where the DR8 luminaire
is to be installed is compatible with the Eutrac 1-Circuit
adaptor.
C
1-Circuit Track Installation
If the spotlight is to be controlled via DMX or DALI,
ensure that track system includes Data Bus. See For
more information on DMX Installation see DOC-083.
NOTES
N
L
*note orientation
2
To mount the track adaptor into the track system, first
check that both the selector knob and the adaptor
lock are disengaged, as shown below.
3
4
5
Insert the track adaptor into track system. Take care
to avoid any fixing screws holding the track onto the
ceiling.
Rotate adaptor lock clockwise 90° to connect the
adaptor to the neutral circuit.
When installing the adaptor into the track, ensure that
it is orientated correctly. Align the tabs with the
slot on the track.
1
D
Monopoint Installation
The monopoint fixture requires a minimum clearance
distance of 200mm above and around the mounting
point and a maximum ceiling material thickness of
50mm.
200mm MIN.
200mm MIN.
50mm MAX.
2
3
Mark up the ceiling and cut a circular hole 112-114mm
in diameter.
For multiple installations, ensure a minimum distance
of 250mm between mounting points.
Ø112 - 114mm
250mm MIN.
PAGE 5
6
Rotate selector knob to the desired circuit position
(see section 7).
7
The Eutrac 2-Circuit track adaptor is compatible with
a number of different 2-Circuit track systems
including Eutrac, Erco & iGuzzini systems. For further
options, please contact RCL.
NOTES
With the 2-Circuit track adaptor, you can choose
which circuit the luminaire is connected to:
Unconnected - The luminaire is not connected to any
circuit.
Circuit 1 - From the unconnected position, rotate the
knob clockwise 90°.
8
When installing multiple fixtures, always allow a
minimum of 250mm between luminaires.
250mm MIN.