INSTALLATIONS
INSTALLATIONS
Fail Locked F2164
(Fire-Rated)
& Fail Unlocked 2364
ELECTRIC STRIKE
Standard Parts:
Insert
Deadbolt Keeper
Deadbolt Plug
Deadlatch Ramp (Auxiliary Bolt Bracket)
Keeper Sliding Shims: 1/16" (1.5mm) and 1/8" (3.0mm)
A Centerline Latch Faceplate and an Offset Latch Faceplate are provided.
Both are: 4-7/8" x 1-1/4" (123.8mm x 31.8mm)
Trim Plate
12VDC or 12 to 24VAC Cable Connector
24VDC Cable Connector
Anti-Tamper Security Screws (2x 12-24) and Bit
Mounting Tab Kit (2x tabs, 4x shims and 5x 12-24 screws)
Inductive Kickback Suppressor - MOV
Wiring Instructions
Use the appropriate wire harness supplied.
12V for 12VDC & 12-24VAC
24V for 24VDC only
Attach the red wire to (+) positive of the power supply.
Attach the black wire to the (–) negative of the power supply.
If using AC power, polarity is not observed.
To meet BHMA A156.31, install the MOV provided across the
positive and negative wires or terminals of the harness. The MOV
is not polarity sensitive.
NOTE: If a suppression diode is required for access control,
observe proper polarity.
Latch Monitor Wires
Black = Common (C)
Blue
= Normally Closed (NC)
Orange = Normally Open (NO)
Red
Black
+
-
+
-
Red
Black
24VDC
Terminal
12VDC
12-24VAC
Terminal
N
O
N
C
C
Latch
Monitor
Optional LM
Wiring the 2 Series Electric Strike
*Warning: The fire and security ratings shown on the strike labels no longer apply with the use of this faceplate.
The F2164 fail secure locking mechanism shall only be installed where allowed by the local authority having jurisdiction and shall
not impair the operation of the panic hardware or intended operation of the emergency exit.
These strikes must be connected to a compatible UL Listed Burglary or Access Control Power Supply.
PCN15058
R06/16GR
© 2016 RUTHERFORD CONTROLS INT’L | A DORMA GROUP COMPANY
WWW.RUTHERFORDCONTROLS.COM • PHONE: 1.800.265.6630 • FAX: 1.800.482.9795 • E-MAIL: [email protected]
ISF2
Accessories:
Latch Monitor Switch : F2LM
9" Centerline Latch Entry Faceplate : F2-19*
9" Offset Latch Entry Faceplate : F2-29*
Filler Plate - 2 Series Strike : 2FP
UL 294 Performance Ratings:
Access Control Line Security : Level I
Destructive Attack : Level I
Endurance : Level IV
Standby Power : Level I
