14
Chapter 2
Using the Remote Control
Graphics contained within this publication are for representation only.
Adding a Learned Function
There are several things to consider before you begin the learning process:
•
You can’t record a learned function to the following buttons on the TV’s remote control: component
buttons (TV, VCR, DVD, SAT/CAB, AUX/HD, and AUDIO), the CLEAR button, and the LIGHT
button.
•
Before adding a Learned Function, you must program this TV’s remote control to operate that
component because programming the remote control erases all learned commands for that
component mode.
•
Do the learning process in low light areas because too much natural light or fluorescent light might
cause the learning feature to fail because the remote control functions are recorded (learned) by
sending infrared (IR) signals.
•
The TV’s remote and the original remote should be no more than 2 inches apart.
Up to 2 inches apart
•
In order to record (learn) a function from one remote to the other, you must make sure the Infrared
(IR) transmitter of the original remote is facing the IR receiver on the top of the TV’s remote (see
illustration). To accomplish this, you may have to hold a remote in each hand instead of laying both
on the table.
•
The learned buttons are mode specific—if you add a button function from your DVD player’s remote
control, you must press the DVD button first before the learned function will work (in TV mode, the
button where you’ve stored the learned function will continue to work as it always has).
1. Press and hold the component button on the TV’s remote that applies to the function you will be
adding (DVD, VCR, SAT/CAB, AUDIO, or AUX/HD). The component button lights.
2. On the TV remote, press and hold the RECORD button.
3. Keep pressing both of the buttons (the component button and the RECORD button) until the
component button light turns off, flashes, and turns off. Release both buttons.
4. On the TV’s remote control, press and release the button where you want to store the new
function (the component button turns off and then back on).
Note:
If you press an invalid button on the TV remote, one of the component button flashes 4 times
to alert you. You’ll have to repeat step 4.
5. With the remote controls facing each other and no more than 2 inches apart, press and hold the
button of the component’s remote control that has the functionality you are recording to the TV’s
remote control. Keep pressing the button until the TV remote’s component button light turns off
and back on (the function has been saved to the TV remote). If all component buttons flash 4
times, the function wasn’t learned. Try again starting with Step 4.
6. The TV remote control remains in “learning mode” so you can continue adding functions to
different buttons by repeating steps 4 and 5. Or, press CLEAR to exit learning mode.
Notes:
If you want a new function on a button, you must record (learn) over it.
The amount of memory each learned function uses in the TV’s remote control varies. If your TV
remote is out of memory, the component button(s) light flashes 4 times and turns off, exiting you
from the Learning mode.
16278190.02 Remote
4/13/04, 4:32 PM
14
Содержание Scenium LCDX3022W
Страница 1: ...LCD Television User s Guide ...
Страница 4: ...This page left intentionally blank ...
