Power
operation
Function
operation
3
4
Note :
1. Install 4 AA size batteries into the the battery compartment on the underside
of the unit. Be sure to observe the polarity markings shown on the inside of
the compartment. Always replace old batteries with the same size and type.
1. Insert the small round end of the mains adaptor into the DC
input socket on the rear of the unit.Connect the 3 pin adaptor to a
suitable wall socket and switch on.
When using battery power, always switch the unit to standby mode
before connecting the mains adaptor.
ALARM button to
2
.
In
the
event
of
mains
power
faiure
,
the
time
is
maintained
by
the
batteries
.
Setting
the
clock
1.In standby mode,press and hold the CLOCK button until the HOUR
digits flash in the display. Press the SET+/SET- buttons to set the hour
digit. Press the CLOCK button to confirm.
2.The MINUTE digits will flash. Press the SET+/SET- buttons to set the
minute digit.Press the CLOCK button to confirm.
3.The Day lndicator will flash.Press the SET+SET- buttons to select the
desired weekday (MON to SUN), then press the CLOCK button to confirm
the day.
4.When setting the CLOCK or alarm time, the display will return to the
previous mode if no buttons are pressed after 5 seconds and the last
selected value will be saved.
To turn the Clock Radio ON, press and hold the STANDBY/ON button.
The red power indicator will turn on.
To turn the Clock Radio OFF, press and hold the STANDBY/ON button
again.
Battery
Installation
AC
Power
Supply
Connection
Setting
the
alarm
1. In standby mode press and hold the ALARM button until the hour digits flash in
the display. The alarm icon will also flash.
Press the SET
+
/
SET
-
buttons to set the hour digit. Press the
confirm.
5. Press the ALARM button to confirm. The display will return to clock mode.
3. The day icons will flash. Use the SET+/SET- buttons to select either 5 day alarm
or 7 day alarm mode. Press the
ALARM button to confirm.
4. The alarm mode icon will flash. Press the SET+/ SET- buttons to select
either Radio,iPod or Buzzer
alarm mode.
2. The MINUTE digits will flash. Press the SET
+
/
SET
-
buttons to set
the minute digit.
And then press the ALARM button to confirm.
