![RCA RACE5002E Скачать руководство пользователя страница 12](http://html.mh-extra.com/html/rca/race5002e/race5002e_owners-manual_17400012.webp)
REMOVAL FROM WINDOW
Turn off the air conditioner and disconnect the power cord. Remove the 5 screws installed through the
window and the air conditioner, and save for reinstallation later. Close the guide panels. Keeping a firm
grip on the air conditioner, raise the sash, and carefully tilt the air conditioner away from you to drain any
condensate water. Remove the air conditioner from the window .
CAUTION
When handling the air conditioner, be careful to avoid cuts from sharp metal fins on front and rear coils.
Make sure air conditioner does not fall during removal.
Air conditioners covered in this manual pose an excessive weight hazard. Two or more people are needed
to move and install the unit.
To prevent injury or stain, use proper lifting and carrying techniques when moving unit.
Note
: Please note that there is a screw on the left and right side of the air conditioner covered by the curtain
fastening strips. Before disassembling the unit please first take out the curtain fastening strips then loose
the screw on each side, as shown in FIG.13.
CURTAIN FASTENING STRIP
SCREW
FIG.13
11
11
Install a second wood strip(approximately 6
long by 1.5
wide and same thickness as first strip) in the
center of the outer sill flush against the back of the inner sill, as shown in FIG.12.
IF AIR CONDITIONER IS BLOCKED BY STORM WINDOW FRAME
If storm window presents interference, fasten a 2
w
ide wood strip to the inner window sill across the
full width of the sill. The wood strip should be thick enough to raise the height of the window sill so that
the unit can be installed without interference from the storm window frame. See FIG.12.
Proper clearance enhances the cooling efficiency of the unit and prevents heat radiation of the condenser.
The top of the wood strip should be approximately 0.75
higher than the storm window frame or wood
strip to help condensation to drain properly to the outside.
If the distance between storm window frame and wood strip mounted on top of inner sill is more than 1
two of wood strips are not necessary.
1
MAX
WOOD STRIP
MOUNTED
ON TOP OF
INNER SILL
INNER
SILL
INSIDE
OUTSIDE
OUTER SILL
STORM
WIDOW
FRAME
0.75
OLEARANCE
FIG.12
INSTALLATION
3