B.
In factory mode, enter the Balance menu and change the input source to HD. And
press Pro.-/+ key to select YUVcalbr and press Vol.+ key to activate
C.
Input the pattern as below from a DVD player.
D.
Enter the ADCBal. Menu, and adjust Y/G Offset until the darkest scale is just
obvious. Then adjust Y/G Gain until the brightest scale is just obvious.
E. Input a 10 Gray Scale signal (Timing 35, PATTERN 46, 480I) from Chroma 2327, and
then measure the balance in the center area with a Color Analyzer. (Note: the distance
between the screen and the sensor is 25-30 cm )
F. Adjust the value of R Gain and B Gain until the color coordinate is x=285±15,
y=294±15.
2.
Check the settings in the Factory mode:
Note
：
a. After the first power-on or downloading, please enter the factory mode and activate
the Reset Data function.
b. Before delivery, enter the factory menu and select All For User in System menu.
And then press Vol.+ key to activate.
Item Default
Description
**System menu**
G
Ｍ
--
Reset User D
Reset user Data
Language
OSD
Language
ServiceM
Service menu
Reset Data
Reset all the Data
All For User
Set user Data to defaulted values before delivery
Power On
Power on mode after the unit is switched up:
( 0—power on directly,
1—remember the last state before powered off,
2—standby after powered on)
Factory
Select the method of entering the factory menu
( ON—press PC key to enter directly,
OFF—must input password)
**Balance menu**
Source
Input source selection
R Offset
R offset for black balance adjustment
15
