RCA F19426, Руководство пользователя

Страница: 20 / 64

Connections & Setup
18 Chapter 1
Step 3: Configuring for a VCR
1. If your TV is connected to a VCR, press OK.
If it is not, highlight
No
and press OK (a screen
appears reminding you to connect your G-LINK cable
to your TV and VCR).
3. Tune your VCR to channel 02. Next, turn OFF your
VCR. When you complete these steps, press OK to
begin testing.
Important Note: When code testing is in
progress, don’t touch your TV, VCR, or any of
the remote controls for these products.
4. Look at the front of your VCR. If your VCR turned on
automatically and changed to channel 09, the test
was successful. Highlight
Yes and press OK.
If your VCR didn’t change to channel 09, you can
either choose
No or Test this code again.
If you think your TV or remotes might have been
touched during the test, tune your VCR to channel 02,
turn off your VCR and highlight
Test this code again .
If you don’t think the test was interrupted, highlight
No . Tune your VCR to channel 02 and turn off your
VCR. Press OK (the GUIDE Plus+ system starts testing
another set of codes.)
Keep following the previous instructions until the
VCR finds the correct code.
2. Use the up and down arrow buttons to highlight the
brand of your VCR that is connected to the TV.
If your brand isn’t listed, highlight Not Listed and
press OK.
15720240.01 Setup 4/9/02, 1:00 PM 18