RCA DIRECTV, Руководство по установке

Страница: 23 / 48

Chapter 2 21
Mounting the Mast
No
Yes
Step 8: Make sure that the top of the mast is plumb (pointing straight up).
Wall
Metal Channel
Fold In
Step 6a: Slide the metal channel
through the hole.
Step 6b: Make sure the plastic cap is
flush with the wall.
;;
;;
;; ;;
;
;
;
;
Step 6c: Snap off straps flush
with the wall.
6. Install the togglers:
a. Carefully fold one end of the metal channel along the plastic straps.
Hold the metal channel flat against the plastic straps and slide it through
the hole.
b. Pull the ring so the metal channel rests flush behind the wall. Hold the
ring tight and slide the plastic cap along the straps until the cap is flush
with the wall.
c. Push the straps side-to-side to snap them off flush with the wall.
d. Repeat for all eight holes.
7. Use a 7/16" wrench to loosen the nuts on the mounting foot so you can rotate the
mast to access both of the center mounting holes.
8. Hold the mounting foot over the holes so the top part of the mast will rotate and
point straight up. For the final mounting, you should use the bubble level inside
the EZALIGN™ mast to make sure the mast is perfectly plumb and level.
9. Place washers on each of eight #20, 1/4" x 3" machine screws and attach the
mounting foot to the wall. Securely tighten the screws.
10. Go to the next section, “Final Installation,” to complete the installation process.
Wall
Plastic Cap
Ring
Metal
Channel