RCA BR200DV, Руководство по обслуживанию

Страница: 29 / 79

BR200DV/BR300DV
Service Manual
29
Control voice prompt content
Memory (FLASH)
Channel data, CTCSS/DCS data and other function setting data and parameter adjustment data.
CTCSS/DCS signal coding and decoding:
CTCSS/DCS signals from MCU are sent to TCXO for modulation respectively .
CTCSS/DCS signals from receiver are sent to MCU(pin 25) for decoding, and then MCU test if there
are CTCSS/DCS signals with the same setting of the station to decide whether open the speaker or
not.
CTCSS (continuous tone control squelch system, hereinafter referred to as CTCSS), is a kind of
squelch control system with modulation on carrier and continuous sub-audio signals as pilot tone. If
CTCSS function is set, the call is available only at the same CTCSS frequency of both receiving and
transmitting parties to avoid the disturbance of other signals.
The station has 39 groups of standard CTCSS frequency for your selection, such as Table 1.
CTCSS signals produced by MCU are sent to TCXO for modulation.
Table 1 CTCSS Frequency Table
No. Frequency
[Hz]
No. Frequency
[Hz]
No. Frequency
[Hz]
No. Frequency
[Hz]
1 67.0 11 94.8 21 131.8 31 186.2
2 69.3 12 97.4 22 136.5 32 192.8
3 71.9 13 100.0 23 141.3 33 203.5
4 74.4 14 103.5 24 146.2 34 210.7
5 77.0 15 107.2 25 151.4 35 218.1
6 79.7 16 110.9 26 156.7 36 225.7
7 82.5 17 114.8 27 162.2 37 233.6
8 85.4 18 118.8 28 167.9 38 241.8
9 88.5 19 123.0 29 173.8 39 250.3
10 91.5 20 127.3 30 179.9
DCS signaling
：
DCS (Digital code squelch), is a kind of continuous digital code modulated on carrier with voice signal
and used for squelch control. If DCS function is set, the speaker is available only when receiving the
same DCS code to avoid the disturbance of useless signals.
The station has 83 kinds of standard codes including positive and inverse code for your selection, such
as Table 2.
DCS signals produced by MCU (PWM waveform) are sent to TCXO for modulation.
CTCSS/DCS signals from receiver are sent to MCU for decoding, and then MCU test if there are DCS
codes with the same setting of the station to decide whether open the speaker or not.