REINSTALLATION
1. Remove the lower pivot pin from the lower
hinge by turning counter clockwise. Move the
pin to the opposite hole and tighten. Make sure
that washer on the pin stays in place (Fig. 5)
2. Tilt refrigerator on a 45-degree angle to have
access to the bottom front.
3. Remove both left and right front feet from
bottom. (Fig. 6)
4. Loosen the screws holding the bottom hinge
and remove it using ratchet wrench with 10 mm
socket. Remove one Phillips Head screw on
other side.
5. Align the holes in the bottom hinge to the
corresponding holes on the opposite side of the
cabinet. Insert and tighten the screws. Reinstall
both front feet and reinstall Phillips Head screw
on opposite side.
6. To install refrigerator door: Line up the left
bottom hole of the refrigerator compartment
door over the bottom hinge pin. Move door
forward to make it straight and align with
central hinge. Install the central hinge again, and
turn the hinge axle until it completely enters the
door body. Secure it with the screws provided.
(see Fig. 7)
NOTE:
Prior to this, remove plugs from door
frame and install on opposite side.
7. To install freezer door: Line up left bottom
hole of the door over the central hinge middle
pin. Move door forward to make it straight and
align with freezer compartment. Place over left
side the top hinge, align holes with hole on the
refrigerator top and tighten with the screws
provided. (see Fig. 8)
8. Reinstall hinge cover as shown in Fig. 8
8
REVERSING THE DOOR SWING CONT.
Two People Required.
CAUTION
Fig. 5
Fig. 6
Fig. 7
Fig. 8
