77
Unlink the LumenDimM4micro
If the blue RF Connect LED on the LumenDimM4micro blinks continuously, it is
looking for a transmitter that it was previously linked with.
To unlink it, press and hold RF Connect for several seconds until the blue LED
goes off and stays off.
If the RF Connect LED remains on, or is blinking, repeat the process until it
stays off.
When the RF Connect LED is off, the LumenDimM4micro is ready to be linked
to your transmitter.
Link status is not affected by performing a Factory Reset. You must
intentionally unlink to disconnect from a previously linked transmitter.
NOTE:
When using a wired RDM controller plugged into the miniplug DMX
connector, wireless DMX data must be stopped. This can be done by unlinking,
turning off the wireless transmitter, or disconnecting the wired DMX data going
into the transmitter.
