RC Logger 88001RC, Руководство по эксплуатации

Страница: 21 / 40

P. 21
Observe that the composite signal converters are assigned without gaps! in a 6-channel system, this means inputs 1 - 6
and not 1 - 4 and then 6 and 7. With this assignment, the electronics would not recognized channels 6 and 7!
due to the many remote control receiver sizes and builds on the market, we cannot give any detailed installation notes
for the receiver. depending on the receiver used, you may either install it between the PCBs in the grid frame of on the
reinforcement plate.
Attach.the.receiver.firmly.on.the.stabilizer.with.double-side.adhesive.tape.(not.included).or..any.other.material. 2.
PvC tube for antenna with rubber cap (optional)
If.your.receiver.consists.a.long.antenna,.you.may.insert.it.into.the.PVC.tube.for.antenna.(Box.4-f)..And.then.insert.the.PVC.tube.for.the.
antenna into the antenna holder on the bottom body frame.
Battery installation
The user may use any alternative method to connect the battery cords. However, user should ensure the positive and negative part
of the cords are well protected and will not be short-circuited. In this example, we use a pair of heat shrink tubes to cover the cords.
Pass.the.battery.cords.(Box.1-c-II).through.two.heat.shrinks.(not.included). 1.
Solder the cords to the corresponding terminal of your battery. 2.
Move.the.heat.shrink.to.cover.the.soldering.part,.apply.heat.to.shrink.the.heat.shrink.tube. 3.
the battery may be short-circuited if the connections are not protected correctly. this may cause damage both to the
battery and the RC EYE 650. Loss of guarantee/warranty!