1. Attach the Universal Mounting
bar with the bar screws (provid-
ed) to the junction box. If you are
attaching your STL200 kit to a
surface mount weatherproof box,
you must use the metal plate with
the attached gasket. The gasket
faces the Junction Box.
2. Easy Wiring Tip:
Use the “S” shaped Hands Free
Hanging Hook to hold the EZ Plate
during wiring.
3. Bring power leads and sensor kit
leads through holes in all gaskets
into junction box.
4. Strip
1
/
2
" of insulation from all
leads.
5. Attach ground wire(s) to junction
box grounding screw. Connect
as shown in wiring diagram (pg 5).
6. Twist on wire nuts. Secure with
electrical tape.
7. Align EZ Plate and metal
mounting plate to insure
proper seal. Tighten EZ Plate
center screw (make sure O-Ring
gasket is on the screw) to attach
EZ Plate to the box. There are
2 screws supplied. Use the one
which suits your assembly
best.
8. Insert plastic Finishing Cap in
the center of the EZ Plate for a
weatherproof seal.
9. Use silicone sealant around all
openings to insure a
weatherproof seal.
10. Screw in light bulbs. Turn on
power. Conduct walk test to
adjust sensor response (pg 6).
Kit Wiring
Black
Black
Red
Red
(pigtail)
Ground
Ground
Power In
White
White
Red pigtail is only used to switch remote or
additional fixtures.
4
EZ Plate
1. Lights may turn on occasionally
during rain, snow and windstorms
because the sensor is detecting
changes in temperature.
Solution:
Mount sensor in protected area.
If false detections are a constant
problem, reduce sensitivity (turn
counterclockwise) until the problem
stops.
2. Tilt the sensor lower, it may be
seeing distant objects moving.
3. You may not be aware that
animals have triggered the sensor.
Check sensor aiming to reduce
nuisance triggering or mask the
lower part of the lens with opaque
weatherproof tape to create an
“Animal Alley”.
4. Although it is surge and transient
protected, the sensor may turn on
occasionally during extreme voltage
surges.
5. A possible source of “mysterious”
sensor activations are strong local
radio signals. Check for nearby CB,
Ham, VHF radio transmitters or
Cellular telephones. The sensor may
be activated but will not be perma-
nently impaired by these signals.
6. Check all the Solutions mentioned
under “Lights Turn On and Off”.
7. Check items #2, 4, 5, 6 and 7
under “Lights Do Not Turn Off.”
Technical Tips:
Lights Turn On for Unknown Reasons
10’
50’
This is the
ll
A
l
a
m
i
n
A
“
ey”
11
Bar
Hook
Screws
CU4 EZ
Plate
Universal
Mounting Bar
Gasket
Center
Screw
Insert
close-up
plugs in
unused
holes
Finishing
Cap
O-Ring Gasket
