2
How large an area does the
LOSBAY800 cover?
The Bay Lens and Aisle Lens are
designed for 20’ to 40’ mounting
heights with a symmetrical coverage
pattern of 50’ to 60’ in diameter.
The L0SBAY800 sensor “sees” infrared
heat changes caused by movement
within the detection zone and turns
on lights automatically.
How long do the lights stay on?
Lights stay on as long as motion is
detected. The controlled lights ( on
the same circuit) will remain ON until
no more motion is detected and the
pre-set time-delay has expired. You
can adjust the delay from 30 seconds
to 30 minutes.
How much motion is necessary to
keep lights on?
In order to activate the sensor, the
source of heat must move from one
zone of detection to another. It is
recommended to mount the sensor
at least 6’ away from heating, cooling
and ventilation perpendicular to the
direction of movement.
How Do RCL Occupancy Sensors Work?
3
LOSBAY800-IN-1212 RCL
30’
30’
40’
20’
20’
Aisle
Top View
360
°
Top View
30’
30’
40’
30’
30’
TIME
LUX
5
15
25
‚
30MIN.
30SEC.
‡
‡
Lux
Time
CAUTION: For your own safety and
to prevent damage to the unit, turn
off ALL power by removing the
power fuse or turning off the circuit
breaker.
•
Please read the entire Installation
Manual before proceeding.
•
All wiring should comply with
local electrical codes and requires
a qualified electrician.
•
Use this device with copper or
copper clad wire only. With
aluminium wire use devices
marked CO/ALR or CU/AL only.
•
Be sure the total lighting load
connected to the LOSBAY800 does
not exceed the following ratings:
120VAC:
800VA - 6.67A, 50/60 Hz
277VAC:
1200VA - 4.33A, 50/60 Hz
347VAC
: 1500VA - 4.32A, 50/60 Hz
•
INSTANT START FLUORESCENT
BALLASTS MAY NOT BE RATED
FOR USE WITH ANY KIND OF
OCCUPANCY SENSOR.
•
THE LOSBAY800 CANNOT BE
USED WITH DIMMERS.
• Operating Temperature:
-10°C to 70°C (14°F to 160°F)
Relative Humidity: 20-85%
• Power Consumption:
2W@120V,
1W@277V,
0.8W @347V
Warmup:
After the power is turned ON, allow 2
minutes for warm up. The controlled
lights will be on for the entire 2
minutes. After warm up is complete
the unit will operate according to set
time delay and lux settings.
LED:
The sensor has an internal green LED,
visible through the lens, which
activates when motion is detected.
Time:
This ‘Time’ knob controls the amount
of time lights stay ON after the last
detected motion. Settings varying
from 30 seconds to 30 minutes.
Photocell:
The ‘Lux’ knob controls the light level
at which the sensor will switch on the
lights when movement is detected.
If set to the maximum (“sun”) it will
switch during most lighting
conditions. If set to minimum (“moon”)
the sensor will only operate at dusk or
light conditions darker than dusk. This
is the ideal position for general early
evening and night operation.
