RBP-510-RX7
Page 1 of 3 05/14/20
1300 TEMPLE AVE, CITY OF INDUSTRY CA 91746 1-800-237-7506
HARDWARE INCLUDED
RECOMMENDED TOOLS
1
Driver/Left RX7 Side Step
24
10mm x 27mm OD x 3mm Flat Washers
1
17mm Wrench and /or Socket
1
Passenger/Right RX7 Side Step
12
10mm Nylon Lock Nuts
1
13mm Wrench and/or Socket
1
Driver/Left Front Mounting Bracket
6
8-1.25mm x 35mm Hex Bolts
1
10mm Wrench and/or Socket
1
Passenger/Right Front Mounting Bracket
6
8mm Lock Washers
1
Driver/Left Center Mounting Bracket
6
8mm x 28mm OD x 3mm Flat Washers
1
Passenger/Right Center Mounting Bracket
12
6-1.0mm Hex Bolts
1
Driver/Left Rear Mounting Bracket
24
6mm x 22mm OD x 2mm Flat Washers
1
Passenger/Right Rear Mounting Bracket
12
6mm Nylon Lock Washers
12
10-1.5mm x 35mm Hex Bolts
STEP 1- Remove any old steps or factory installed side product and hardware from vehicle.
STEP 2- Start installation on the Driver/Left side of the vehicle. Locate the (3) pairs of holes in the pinch weld,
(Figure 1). Move to the front mounting location, (Figure 2). Select the Driver/Left Front Mounting Bracket.
Attach the Bracket to the floor panel with (1) 8mm Hex Bolt, (1) 8mm Lock Washer and (1) 8mm Flat Washer,
(Figure 3). Attach the Bracket to the pinch weld with (2) 6mm Hex Bolts, (4) 6mm Flat Washers and (2) 6mm
Nylon Lock Nuts, (Figure 3). Do not tighten hardware at this time.
STEP 3- Move to the center location, (Figure 4). Select the Driver/Left Center Mounting Bracket. Repeat Steps 2
& 3 to attach the Center Bracket to the center mounting location, (Figure 5).
STEP 4- Move to the rear location, (Figure 6). Select the Driver/Left Rear Mounting Bracket. Repeat Steps 2 & 3
to attach the Rear Bracket to the rear mounting location, (Figure 7).
Passenger/Right
Rear Mounting Bracket
2018 + JEEP WRANGLER JL 4DOOR RX7 SIDE STEPS
Front
Passenger/Right
Front Mounting Bracket
Driver/Left Front
Mounting Bracket
Driver/Left Rear
Mounting Bracket
Driver/Left
Side Step
Passenger/Right
Center Mounting Bracket
Driver/Left Center
Mounting Bracket
