3
ASSEMBLY AND SET-UP
2
Place the handlebar pad over
the handlebars and secure tightly
with the velcro cover.
1
Align the holes on the handlebars and the T-bar. Insert handlebar bolts
into the top of the handlebar and through the T-bar. Install the washers and
nuts onto the bottom of the handlebar bolts. Tighten securely into place
using a 10 mm wrench.
Assembling the Handlebars
Tools required: 10 mm wrench
3-1
3-1
3-3
3-3
3-4
3-5
3-5
3-2
3-2
Assembling the Rear Wheels
Tools required: Two (2) 5 mm Allen wrenches
1
Remove the locking screw, spring washer, small washer and large washer
from one side
of the axle bolt. Insert
the axle bolt through the rear wheel. Insert the large washer (3-5) onto the axle bolt between the frame and rear
wheel and slide the axle bolt through the frame. Slide the other large washer and wheel onto the axle bolt.
Note:
Wheels are interchangeable.
2
Insert the small washer (3-3), spring washer (3-2) and locking screw (3-1)
onto the axle bolt and tighten securely using two (2) 10 mm wrenches.
3
Make sure the locking screw,
spring washer and small washer
are securely tightened against
the wheel.
3-1 Locking Screw
3-2 Spring Washer
3-3 Washer (Small)
3-4 Axle Bolt
Wheel
3-5 Washer (Large)
Rear wheel hardware sequence
Frame
Note:
For further assistance, please
refer to page 6 for parts breakdown.
