Razor Ground force Drifter 25143400, Руководство пользователя

Страница: 5 / 12

4
Turn power switch off before conducting any maintenance procedures.
Need Help? Visit our web site for replacement parts, product support and a list of authorized service centers
at
www.razor.com
or call toll-free at 866-467-2967 Monday - Friday 8:00 AM - 5:00 PM Pacific Time.
ASSEMBLy AND SET-UP
q
Charging the Battery
Your Ground Force Drifter may not have a fully charged battery; therefore you must charge the battery prior to use.
• Initial charge time: 18 hours • Run time: up to 40 minutes
• Recharge time: up to 12 hours • Average battery life: 250 charge/discharge cycles
• Fully charge once a month when not in use • Do not store below 32 degrees F°- this can damage the battery
q
Self Adjusting Chain Tensioner
1
Plug the charger into the port on
the Ground Force Drifter. Make sure
the power switch is in the “OFF”
position.
2
Plug the charger plug into wall outlet.
WARNING: Use
ONLY with the recommended
charger. Batteries are only to be
charged under adult supervision.
The charger is not a toy. Always
disconnect your Ground Force
Drifter from the charger before
cleaning with liquid.
The charger supplied with the
Ground Force Drifter should be
regularly examined for damage to
the cord, plug, enclosure and other
parts. In the event of such damage,
the Ground Force Drifter must
not be charged until it has been
repaired or replaced.
Note: The charger has a small
window with one LED to indicate
the charge status. Refer to the
illustration on the charger unit
for the actual “charging” and
“charged” status indications for
your model charger.
Chargers have built-in over-charge
protection to prevent battery from
being over-charged.
Note: Proper alignment of the chain must be maintained. If the chain is adjusted properly, but is noisy or rough run-
ning, check alignment of the sprockets. The drive -shaft sprocket can be adjusted slightly from side-to-side by loosen-
ing the set screw. Note that a key maintains the drive position to the shaft.
Motor shaft sprocket
Roller chain
Fixing Bolt
Drive shaft sprocket
Note: If the charger gets warm during regular use, this is a normal response and is no cause for concern. If your
charger does not get warm during use, it does not mean that it is not work properly.