HEADLINE
3
BEFORE YOU BEGIN
3
Remove contents from box. Remove the separators that protect the components from damage during shipping.
Inspect the contents of the box for scratches in the paint, dents or kinked cables that may have occurred during
shipping. Because the scooter was partially assembled and packed at the factory, there should not be any problems,
even if the box has a few scars or dents.
MAKE SURE POWER SWITCH IS TURNED “OFF” BEFORE CONDUCTING ANY ASSEMBLY OR
MAINTENANCE PROCEDURES.
Estimated Assembly and Set-Up Time
Allow up to 10 minutes for assembly, not including initial charge time.
Allow up to 12 hours for charge
(see page 5 for charging information)
.
WARNING:
DO NOT USE NON-RAZOR
PRODUCTS WITH YOUR RAZOR
ELECTRIC SCOOTER. Razor scooters
have been built to certain Razor
design specifications. The original
equipment supplied at the time of
sale was selected on the basis of
its compatibility with the frame,
fork and all other parts. Certain
aftermarket products may not be
compatible and will void
the warranty.
3.
Charger
(Note: Charger design may
vary from one shown)
Required Tool
5 mm
Allen Wrench
Twist-Grip Throttle
LED Headlight/Taillight Power Button
Brake Lever
Battery
Control
Module
ON/OFF Switch
Charger Port
Reset Button
Hub Motor
Collar Clamp
LED Tail/
Brake Light
Fork
Handlebar
Stem
Limiter
1.
2.
Product ID Locations:
(See locations to the left)
1. Handlebar Stem
2. Underneath Product
3. Charger
4. UPC Side of Box (Not Shown)
Box Contents:
• E300 HDL
• Charger
• Allen Wrench
• Owner’s Manual
Need Help?
Visit our website for replacement parts, product support, a list of authorized service centers in the US and customer service contact information
at
www.razor.com
. Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer
Service contact information is listed at the back of this manual.
LED Headlight
Note: Electric scooter must
be moving at least 3 mph (5
km/h) while applying throttle to
engage motor.
