Raze 63356, Руководство пользователя

Страница: 4 / 20

GB_MANUAL 4
 Avoid prolonged exposure to vibration
* Pneumatic tools can vibrate during use. Prolonged exposure to vibration or very repetitive hand and
arm movements can cause injury. Discontinue the use of any tool if you experience tingling, numbness,
discomfort or pain in your hands or arms. You should consult your physician before resuming use of tool.

90 PSI maximum
* This tool is designed to operate at an air pressure of 90 pounds per square inch gauge
pressure (90 PSI) maximum, at the tool. Use of higher air pressure can, and may cause
injury. Also, the use of higher air pressure places the internal components under loads
and stresses they were not designed for, causing premature tool failure.
* DO NOT extend too much or stand on unstable support. ALWAYS keep the foot at balance.
* USE ONLY Impact Sockets & Accessories. ONLY USE sockets designated "FOR USE WITH IMPACT
WRENCHES." Hand tool sockets can break, creating a hazard from flying pieces. Always check
sockets, retainers and drives regularly for wear or damage and replace when necessary.
* DO NOT leave the unit energized while it is unattended. When the unit is not
in use, shut down in accordance with the manufacturer's instruction.
* Check for signs of damage. Replace any damaged parts.
* ONLY USE spare parts or accessories specified by the manufacturer.
* Check that all connections are secure before operating this unit.
PRE-OPERATION
Before the tool is connected to the air supply, clear the air hose of accumulated dust and moisture by
running air freely through the air hose for 5-10 seconds. Before removing a tool for service or changing
sockets, Make sure the air line is shut-off at the compressor. This will prevent the tool from operating if the
throttle is accidentally engaged.
INSTALLATION
This tool is designed to operate at 90 PSI. Lower pressure as below 6.2 Bar (90 PSI) will reduce performance
of the tool while higher air pressure as over 6.2 Bar (90 PSI) raises the performance of the tool beyond its
rated capacity and could cause serious damage to tool and user. Always use clean dry air. Excessive moisture
and dirt wilt greatly reduce the life of any air motor. We recommend the installation of an in-line filter-
regulator-lubricator as close to the toot as possible. Be sure all hoses and fittings are the correct size and
tightly secured before using air tool.
OPERATION
This tools is built with a power adjuster. Rotate it until desired output is achieved. The settings on the
regulator are only for reference only and do not denote a specific power output. Turn regulator to position
with smaller circle being the least amount of power and larger circle being for the most amount of power.
The tool operates in maximum power in reverse. Built-in regulator for power output adjustment.