2.3
Molded Seat
The unique seat on all Raz Shower Chairs was designed to help
stabilize the pelvis and was contoured for pressure reduction. The
seat is made from a soft, integral-skin foam and measures 23” wide
by 18” deep. The seat is an element of the unique Ischial Pelvic
Alignment System (IPAS), it provides 1½” of fore and aft adjustment
so that the seat can be aligned with the pelvis. The Molded Seat
readily locks in place for transfers but also removes easily for
cleaning. The seat-to-floor height achievable on the Raz AP600 and
SP600 Shower Chairs is between 19¼” and 24¼” and the chair fits
over most standard toilet bowls when the commode pan is not in
place.
NOTE: 23” x 18” seat comes standard with the Raz Rehab Shower
Chair AP600 and SP600 models.
To install the seat:
1. Open the spring clips by squeezing each inward to unlatch the free end from the seat bracket.
2. Slide the rear of the seat over the rear crosstube as the front of the seat is lowered onto the
frame. Check to make sure that the rear seat brackets hook below the crosstube.
3. Lower the front of the seat until the front seat brackets nestle onto the front seat support tubes.
4. To secure the seat in place, squeeze each clip inward while moving the free end towards the
seat until the spring clips click into the seat bracket under the front support tubes.
Raz AP600/SP600 User’s Manual
20090122
8
1
2
3
To remove the seat:
1. Unlatch the spring clips from the front seat brackets.
2. Lift the front of the seat directly up.
3. Pull the seat towards the front of the chair to unhook the rear brackets.
NEVER ATTEMPT TO CHANGE THE SEAT HEIGHT WITHOUT THE HELP OF A QUALIFIED
DEALER. ADJUSTED SEAT POSITIONS WILL REDUCE THE CHAIR’S STABILITY AND MAY
RESULT IN TIPPING AND INJURY.
IMPORTANT !
