To install the Molded Seat:
1. Open the spring clips by squeezing each inward to unlatch the free end from the seat bracket.
2. Slide the rear of the seat over the rear crosstube as the front of the seat is lowered onto the
frame. Check to make sure that the rear seat brackets hook below the crosstube.
3. Lower the front of the seat until the front seat brackets nestle onto the front seat support tubes.
4. To secure the seat in place, squeeze each clip inward while moving the free end towards the
seat until the spring clips click into the seat bracket under the front support tubes.
2
Raz AP/SP User’s Manual
20090122
9
1
3
To remove the Molded Seat:
1. Unlatch the spring clips from the front seat brackets.
2. Lift the front of the seat directly up.
3. Pull the seat towards the front of the chair to unhook the rear brackets.
NEVER ATTEMPT TO CHANGE THE SEAT HEIGHT WITHOUT THE HELP OF A QUALIFIED
DEALER. ADJUSTED SEAT POSITIONS WILL REDUCE THE CHAIR’S STABILITY AND MAY
RESULT IN TIPPING AND INJURY.
IMPORTANT !
2.5
Casters
Each Raz Rehab Shower Chair caster is equipped with a dual-lock
feature, which stops the caster from swivelling and rolling
simultaneously.
To engage the dual-lock, step on the end of the caster lock lever until
it latches in the on position.
To disengage the dual-lock, step on the raised end of the caster lock
lever until it latches in the off position.
FRAME AND SEAT ADJUSTMENTS SHOULD BE PERFORMED ONLY BY TECHNICIANS FROM
QUALIFIED RAZ DEALERS. NEVER ATTEMPT TO CHANGE THE FRAME ANGLE BY CHANGING
THE CASTER POSITION. THE FRAME SHOULD ALWAYS BE LEVEL. IMPROPER CASTER
POSITIONS MAY REDUCE THE CHAIR’S STABILITY AND RESULT IN TIPPING. THIS HAS THE
POTENTIAL TO CAUSE SERIOUS HARM TO THE USER AND/OR DAMAGE TO THE CHAIR.
IMPORTANT !