
2.12
Molded Headrest
The optional Molded Headrest can be ordered with any Raz Shower
Chair Model. The Molded Headrest is shaped to cradle the head
comfortably and is easy to clean. The Molded Headrest can be
adjusted infinitely forward and backwards within a 6½” range, and
vertically within a 12½” range.
Raz AP/SP User’s Manual
20090122
13
To adjust the Molded Headrest:
1. Loosen the bottom tri-lobe knob and adjust the vertical “swan
neck” bar to achieve headrest height adjustment.
2. Loosen the top tri-lobe knob and adjust the headrest
horizontally for a fore/aft change in position.
3. To change the angle of the headrest pad, loosen
(do not
remove)
the three screws on the back of the Molded Headrest.
Rotate the headrest around the end of the headrest mounting
bar to suit the users’ needs and tighten the screws to secure
the desired position.
4. Ensure that all knobs and screws are tightened securely for
the user’s safety.
2.13
Armrests
The Raz Shower Chair comes standard with a Fixed Back and flip-up
padded armrests. Any chair ordered with an Adjusta-Back will have
locking flip-up armrests, and a range for armrest height and angle
adjustment to suit the users’ needs. Also available are 3¼” wide
Molded Flat Armpads, and Molded Arm Troughs as alternatives to the
standard 2¼” wide armpads. On chairs with an Adjusta-Back, the
armrests are height adjustable within a 3” range in ½” increments. The
armrests can be adjusted in height from 7½” to 9½” with the 17”
Adjusta-Back and from 8½” to 10½” with the 20” Adjusta-Backs. The
armrest angle can be adjusted up 5° or down 5° if the backrest angle is
adjusted from the 90° factory position
on an Adjusta-Back only.
To flip up the locking Armrests, release the arm lock by lifting the blue
trigger underneath the armrest tube and lift up the armrest.
ARMRESTS ON RAZ AP AND SP MODELS ARE NOT INTENDED TO SUPPORT THE ENTIRE
BODY WEIGHT OF AN INDIVIDUAL. TOO MUCH WEIGHT MAY CAUSE DAMAGE TO THE
ARMRESTS OR MAY CAUSE THE CHAIR TO TIP.
IMPORTANT !