Raytheon Anschütz NautoPilot 5000 Series, Руководство оператора

Страница: 139 / 191

NautoPilot® 5000 Series
102-890.NG001-NG003
Operator Manual
Edition: 003
123
10000001052
Check Comment
Course Trim
Adjust Course Trim threshold for deviation from Set Track
Course Over Ground.
Softkeys Limit
→
Limit Page (see
also section 1.3.7 and 2.3.6.4)
Heading monitor Adjust Heading Monitor threshold according to traffic in
sea area; the more traffic, the smaller the threshold.
Softkeys Limit
→
Limit Page
(see also section 2.3.6.4)
Track Limit Adjust Track Limit threshold according to traffic in sea
area; the more traffic, the smaller the threshold.
Adjust the threshold at the ECDIS (refer to ECDIS
manual).
At the Autopilot the limit will be displayed only.
OFF Position Limit Adjust Limit threshold for deviation between first and
second position sensor, e.g. position sensor and dead
reckoning.
Softkeys Limit
→
Limit Page
(see also section 2.3.5.5 and 2.3.6.4)
Requirements for
GO- TO-
WAYPOINT
maneuvers.
Check ship’s position and heading in reference to current
waypoint.
(see section 1.4.5.1, Figure 11 for NP5100 to NP5400
and Figure 12 and Figure 13 for NP5500)
Alarm/Status The alarm, warning and status bar (top bar of the display)
should not be red/yellowish orange in color.
The cause of alerts should be resolved.
Alerts should be acknowledged.
4.5.3 Waypoint steering mode in combination with GPS, chart plotter or equivalent
navigation system
Important Note:
The waypoint steering mode may be used on non- SOLAS vessels only. It must not
be used on vessels following SOLAS convention!
IMO has defined 2 different operating modes / systems for automatic steering:
- Heading Control,
- Track Control.
For both of these systems performance and test standards have been defined.
Authorities / classification societies test against these standards and issue a
corresponding certificate if the products are compliant to these standards.
For waypoint steering mode no performance and test standards have been defined