Raytech MUX R, Инструкция по эксплуатации

Страница: 17 / 40

90158-1.08 Instruction Manual Multiplexer Page 17 of 40
4.4.2 Comment
This may be a common full support solution for transformer manufacturers. The WR on the
secondary / tertiary side may be more powerful than the one on the primary side; as usually
a higher current is needed for the low voltage side.
Of course, you can also use a third WR to have an independent current source for every
winding system. Usually it is not necessary, as secondary and tertiary windings are very
similar. It can be measured in series and you can safe one WR meter.
Raytech TR-Mark II/III will on X side be connected to secondary and tertiary Multiplexer. The
operator can easily command TR measurement primary to secondary or primary to tertiary.
4.4.3 Connections: Two WR, one TR and two Multiplexers
Start with the Option and Intercom cables:
Nr. Cable Type Order Nr. Connect on Mux
to Connect on WR
to
1 Option Cables 30493-100 Option In / Out Option Out
2 Intercom Cable 2 Multiplexers 30570-100 Mux Intercom -
1 2