Raytec VAR2 IPPOE i4-1, Полное руководство по установке и настройке, Страница: 20 / 64

20
Ping
The illuminator will respond to a standard Ping command sent to its valid IP address.
For the ping command to work the illuminator and computer must reside in the same
network range.
Basic Troubleshoot

Check if the camera and illuminator are aligned correctly.

For Infra-Red illumination, ensure that a Day and Night or Black and White
camera is used and that the camera switches correctly into night mode.

Check camera and lens. Is iris fully open at night and set correctly. Ensure
camera is fully operational and has correct night time settings and capability.

Ensure correct illuminator lens angle selected for required distance – check
stated performance.

Check the LED status indicator: if green LED indicator is lit on the bottom of
the unit, then the unit is receiving power.

If powering from PoE, ensure Power Sourcing Equipment (PSE) is suitably
rated for the VARIO2 IPPOE unit – see page 6 for required ratings – and for all
8 size units check correct PoE Detection Resistance has been selected – see
page 7.

If powering from low voltage 24V DC, check voltage applied and that power
supply is suitably rated for the VARIO2 IPPOE unit – see page 6 for required
ratings.
 Check connection and wiring of CAT5 / 6 cable to VARIO2 IPPOE. Verify link
has been established with the router / switch to which the illuminator is
connected and that the wiring is compatible with T-568B wiring standard.